I’ve needed M6 bolt after I bought a wrong one, this print fits like a glove! Printed in Prusament PETG in 0.1mm, hope it can hold a cup on our baby stroller.
Metric bolts and nuts fit steel Metric bolts and nuts (V2)
Makes
Comments
I print a M8x25 bolt to use it with a ruler stop I designed. It printed perfectly and fitted to the designed thread of the ruler stop without any difficulty.
I tried the M6 nut and bolt V2.
The bolt fits perfectly, but the nut is very tight.
Thanks for sharing! (edited)
Thank you for your feedback. Good to know others have the same results 👍🏻
What layer hight did you print?
I printed at 0.07mm with Prusament PC blend
printed m4 up to M12 with 0.08 layer height.
they fit each other as well as the original nut and bolt.
nuts are on the tight side
bolts on the lose side
tweaking the bolts and nuts to find a better middle ground. (edited)
Maybe you should test before you publish.
apparently not everyone shares that opinion looking at the likes and downloads ;-)
I know I would not hesitate to try an untested small part if that could be the part i needed.
but now I tested M4 to M12 and they work as intended.
I'm tweaking them a little, for an even better fit.