Shelf Grille - using grid infill

My wife had bought a chrome corner shelf unit for the bathroom. The chrome rails were quite spaced out so you couldn't place small items on them. 

I thought some sort of grille would work but rather than CAD modelling it, I cheated with the slicer. I designed the grille as a solid piece in CAD and then sliced it with no top or bottom layers and used a 10% grid. In a few minutes I had the first grille and a happy wife. 

I made the grilles in PLA as they are so easy and quick to make I'll just replace them if they fail. They've been working fine for 6 months so far. 

Probably not much use as a model, but hopefully a useful tip if you've not used it before. 

Printed in PLA, 10% grid infill, NO horizontal top or bottom layers, 2 perimeters - but if you use the same technique - adjust to suit your application.