Shaving Foam Base Stand

I hate having rusty rings around my bathroom when a shaving foam can gets wet. This quick to print base contains the rust in the edges of the base while letting moisture out of the hole pattern at the bottom. This has fit every shaving foam can that I can test in Ireland as they must be a standard size.

Simple loft design is structurally strong and its depth helps uses the strength of the can as well. The inside seam helps friction fit the can without gripping too hard. 

Tolerances are tight, if you've a good, well calibrated printer, maybe scale the print up by .2mm

Finally re-printing after 2 years of use. My originals are still intact, just full of limescale that I can't get rid of. Images at the end