Nevermore Mount for SV08

As I'm printing ASA I want a filtration system inside my Sovol SV08. There's not really anywhere to fit a Nevermore Micro v6 at the base but this mount can be installed into a top hat at the top of the printer. You could always use it with other printers if you want. 

I made this to work with the 2020 plenum part. It replaces the standard 2020 frame connector part. You can use the same M3 nut and bolt you'd get in a kit to connect the mount to the Nevermore. 

You'll then need 2x M3 heat set inserts and some extra M3 screws of an appropriate length. I am using M3x16 with some holes drilled through Nadir's double height top hat. The design can be used as a drilling template prior to installing the heat sets (or just print 2).

Install photos to come later..