Voron Bowden tube guide with M5 Heatset Insert

I bought some M5x5.8mm heatset inserts that I wanted to use, this seemed like the perfect usecase for them.

Make sure the mating surface between the bearing and the heatset is flat, if any pieces of plastic stick out they might impede the movement of the bearing.

BOM:

1x M5x5.8mm heatset insert

1x M5x10 BHSC

1x F695 bearing

I didn't like that for the bearing version you needed 2 bearings. This only uses one.

Also the bearings in the origional model fell out quite easily, the bearing in this model fits snugly in place.