WWG2 Nitehawk-36 Mount

I didn't like how bulky the available mounts for the NH-36/WWG2 were, so I made my own. This model is a split design so that features can more easily be printed on both sides. The cord grip is PG-7 threaded. 

Print 1x g2_mount and 1x pcb_adapter. If you're using a music wire with your umbilical setup, g2_mount_wire has a small hole/slot to terminate the wire into by inserting, bending to a right angle, then pulling back into the slot.

Hardware required:

• 4x M3x8 BHCS (PCB mounting and motor mount points)
• 2x M3 hex nuts (mount PCB)
• 2x 16mm spacers (motor mount points) - LDO knurled M3 spacers are perfect, or print the ones included in this model (will require 4x heatset inserts)
• 1x M3x35 BHCS (extruder mount point)

Thanks for looking. Leave a make/comment if you use it and any suggestions for improvement if you have them!