Toiletpapier stand

This is a toiletpaper stand that stores toiletpaper. It uses two 3D-printed parts and a 40mm PVC pipe. I had some pipe laying around and thought it would be a good functional excersize to create a toiletpaper stand.

Instructions

Both parts pressure fit into the PVC pipe. If you would like to test if the parts will fit right before printing the bigger parts, i also made a test piece that you could use to test this. It has a hole in the back to put some rope trough so you can pull it back out if it gets stuck. If it doesn't fit, you could use sand paper to make it smaller or some kind of glue to get a solid fit. It goes without saying that you shouldn't glue the top part to the pipe, you'll need to remove this to get toilet paper from the pipe.