Creality CR-10 SE | part fan | part cooling | fan duct | CR-Burner | Dual 5015 blower Fan

Printer Settings:

• Layer Height: 0.2mm
• Material: ABS or PETG

Required Parts:

• M3 × 8mm Screws (7 pcs)  +2 if you want to use the CR Touch mount
• Small Cable Ties
• Heated Inserts: 4.2mm (diameter) × 5mm (length) (4 pcs) +2  if you want to use the CR Touch mount
• Fans: 2 × 5015 Blower Fans

Additional Notes:

• Support is required for the main part during printing (refer to the picture).
• There are mounting spots for cable management and integrated cable channels.

Weight Comparison:

• Original Part Weight: 101g
• New Dual Fan Part Cooling Weight: 108g

I Added a Creality Version of the Cover

• Print with support at the knobs used to align the logo before gluing it together, as shown in the pictures.
• Use a 0.1mm layer height for the logo to achieve better detail.

Someone mentioned in the comments (of the original model) that the BLTouch sensor gets slightly touched by the air duct, but it's no big problem.  Everything works correctly.

(also: 
Andrey E

@evteev_1423294

@matissra it should not push significant on probe. Mounting holes are slightly bigger than screws so you can move the lid slightly. Alse there is little movement on crtouch mount.)

The New Voron like cover is inspired by: https://www.printables.com/model/794438-voron-v02r1-mini-stealthburner-cowling-for-orbiter

Edit: I designed a mount for the CR Touch—if you want it perfectly over-engineered like me, this is for you! 

Some new pictures have been added where you can see the mount in action. There are also some older pictures without the mount for reference.

Klipper Configuration Update

To ensure everything works properly, here’s my Klipper config for the CR Touch:

[bed_mesh]
speed: 350
mesh_min: 12.5,5        # Adjust to handle head distance with BLTouch
#mesh_min: 5,5 original
mesh_max: 205,215
#mesh_max: 215,215   original   # Max probe range
probe_count: 7,7
fade_start: 1
fade_end: 10
fade_target: 0
mesh_pps: 2,2

[bltouch]
sensor_pin: nozzle_mcu: PA9
control_pin: nozzle_mcu: PA10
x_offset: -35.1
y_offset: 2.0
#z_offset: 0 original
probe_with_touch_mode: true
stow_on_each_sample: false
speed: 5
lift_speed: 20
 

Also, line 68 in the standard Creality Klipper config needs to be updated. Change the X and Y values as follows:

bl_offset: -35.1,2.0 # 的偏移量   (English: Touch probe offset)

mounting for dual 5015 blower fans