Shipping Shield Dispenser

A dispenser for your desk, workbench or whatever place you use when packaging cards for shipping. 

Fits the Classic Shields, should fit the Peel & Seal ones too, but I don't have any of those to confirm.

Load them up from the top and there is a slot at the bottom for you to pull them out as you need. Holds around 75 or so.

I printed in PLA, .4 nozzle, .2 layers, 15% infill. Supports are needed for the tabs.

Tolerances are pretty tight with the tabs and slots when assembling, you may need to either sand them down slightly, just give it a good press or maybe light taps with a rubber mallet. Just don't break the thing and get mad at me like I didn't warn you or something.