Razor Holder for Two

Description

A very simple and universal razor blade holder for two. Place it wherever you need it using double-sided adhesive tape. It has been tested with a range of existing razors. In the center of the holder there is kind of drain so that no water remains on the holder. This should keep the holder clean and dry. The edges have been re-enforced. 

Printing

It is designed to be printed without any support or special requirements. Your slicer might complain about a bed adhesion. This wasn't a problem at all in my case, but feel free to add a brim or something. Printed my version in PLA. Even very hot showers should not be a problem for the material. The printing time was around 35 minutes using a 0.6 mm nozzle with a layer height of 0.2 mm.