Panels for the BeamCaseSFF 350mm

These are my panels for the BeamCaseSFF extended to 350mm because that is the length of my BeamCaseSFF (using 320mm aluminum x profile beams). these are inspired of some itx cases that exist on the market (ex: nanoq). 

Notes: 

-I use the case in an inverted layout, but there shouldn't be any problem because the naming is for conventional way of putting the case;

-Leftside and Rightside are if you look from the i/o shield part (do not confuse them because they have different lengths and the holes are aligning in this specific way);

- I strongly suggest to make the brace for the panels that are provided by the original maker of the Beamcase it helps strengthens the side panels

-the underside model is for top, but also for the bottom of the case

please make sure you print them on the good side of the printer with the chamfered holes on top to get the smooth textured part on the exterior.