25mm fan mount for a dual extruding Rostock Max

I don't know if this is useful for other printers or not, but I made it to go on the dual extruder mount that I had previously downloaded and printed for my Rostock Max. It holds a 25mm fan, but needs a shim on the side to hold it in place quietly. I was lucky enough to be able to print this in ABS on a cold bed with the help of extra hold hair spray.

This is based on https://github.com/seemecnc/RostockMAX/blob/master/PRINTED\_ADDONS/70766%2025mm%20fan%20shroud.STL

Instructions

Print this out and snap it onto the aluminum spacers that come with the Rostock Max. You will see in the pictures how I have my extruders set up. I used http://www.thingiverse.com/thing:243270 as the dual extruder mount. You may need to file a little bit of plastic off of some corners if it interferes with the delta arm movement or does not want to fit between your dual extruder mount and your effector. If necessary, unmount the dual extruder mount from the effector or loosen screws. You should probably print this with a brim.