Lighted Owl

My wife loves owls for some reason.  Yeah, they are cool but something about being able to look behind you without turning your body just aint right.  I found this cool black and white print off of Amazon and used that as a template and made it into my own design.  This was printed in 4 pieces that are later assembled into one.  The colored pieces are separate parts that are interference fit into place.  This was before I had the X1C where I could do multiple prints.  This could be adapted to be a single print with a little bit of work in the slicer.

As for the LEDs, just use any strip that you'd like to use and couple it to an ESP32 or similar controller.  This particular setup is using WLED to control timing and patterns.