Bag hanger for table (top) - UPGRADE

UPGRADE - Enlarged hinge lock

Print a bag hanger (top) using ABS or PTEG filament (ABS recommended).

Profile:
Wall loops: 4
Top shell layers: 3
Top shell thickness: 0.8
Sparse infill density: 65%
Sparse infill pattern: Cross Hatch
Enable support
Top Z distance 0.32 mm
Top interface layers: 3
Interface pattern: Rectilinear

The bag hanger can be adjusted as shown in the picture.

Note!!!

After printing, remove the support.

Gently pull and hold the hinge points with your thumb.

The file named Anti-slip pad.stl should be printed from TPU Shore 20D filament and glued (preferably with cyanoacrylate glue).

P.S.
I did not perform load tests.