FLSUN T1 Pro Pi and Screen Bracket

The screen with bracket is a bit bigger than the stock.  For clearance to door it had to be about 10° flatter.

Screen slides into the bezel and gets secured with 4 M2 screws.  Back of the screen is open for the ribbon cable.

The pi bracket fits around the standoffs for the stock mainboard.  A type a usb to type c extension adapter is needed to connect pi to the upper core board mcu.  The 5 pin xh jst from the lower core board to stock main board has a 5v supply.  I made a cable to connect this to power the pi via the 40 pin GPIO.  The stock usb hub has another 5 pin xh jst.  Another custom cable using a usb type a breakout board gets the hub working.  The 5th pin on this connector controls the case light.  Connect this to GPIO12 on the pi.

More at https://github.com/mulcmu/T1-pyro