Prusa Steel Sheet Lack Rack

This is for storing your steel sheets (4off) in the verticle.  

I did this vertically as to avoid sheets bowing when stored in the horizontal.  Fitted to the under side and leg of the Lack Table.  

Included left hand set of files but have not printed them.

Fitting:-

1. Turn table over.
2. Place top guide in position.  Push up against the leg and flat against the underside of the table.
3. Mark hole positions, remove guide and drill holes to suit screw size.
4. Fix top guide in position.
5. Hold a sheet in position and rest bottom guide lightly on edge of sheet.
6. Push against leg in position and mark hole positions.
7. Mark hole positions, remove guide and drill holes to suit screw size.
8. Fix top guide in position.
9. Slide in and out as required.