SMD Strip bin for Mx SMD Roll

This is a remix of two great products:

Mx SMD component strip holder
https://www.thingiverse.com/thing:2186862

SMD Strip Dispenser Tray for Mx SMD Roll
https://www.thingiverse.com/thing:2717152

I was really impressed by how these two products came together. When I was testing out the holder, a few SMD pieces fell out of the strip, and I had nowhere to save them alongside the strip storage container they belong to. I did see that Mx also has an insert for such storage, but I didn't want a separate box for just a few loose pieces.

My solution was to stretch both the original strip holder and the dispenser cover to allow for a bin that could hold the loose pieces. When closed up, you'll have the loose and sealed pieces all in one spot.

After printing my sample, I added a label to the "top" side so that you don't accidentally open the container upside-down and spill those little SMD pieces everywhere. There's also a small recess to put a printed label or sharpie marker label on that "up" side.

Print instructions

Unassociated tags: mx smd, smd storage

Category: Electronics Print Settings

Printer: JG Aurora A3

Rafts: Doesn't Matter

Supports: No

Resolution: Finer is better, but up to you

Infill: 20%

Notes:

No real special requirements for these prints. Like the original, the cover does need to print a few 5mm spans/overhangs, so make sure your settings support that.