KEA Skadis T-Handle Hexkey holder 3X Wera

Print with supports for the pegs! the pegs could be a little tight ( i think it depends on the board, one of mine it fit perfect on the other i had to sand the pegs down a little) 
to put it in angle it and then slide it in ( it wont always go in if you put it in straight! ) 

i modified the angle of the hex-t-handle holder, aswell as shortened it to only be 3x 

for 2mm 2.5 and 3mm wera ( might fit others ) 
hole sizes are 3.5mm  3.5mm and 4mm 

modified the angle of the hex t handles, aswell as shortened it to only be 3 ,  for 2mm 2.5 and 3mm wera ( might fit others ) 
hole sizes are 3.5mm  3.5mm and 4mm