Samsung Fridge Handle

Hi, I was annoyed that I could only open the fridge door from the bottom. I wanted a small handle on the side without the use of screws so I designed this.

You can attach it with two strips of 3M PE Foam tape to the fridge. The handle is supported by the latch at the back. If you don't use 3M or similar PE Foam, the back latch might touch the rubber seal of the fridge.

I printed it with these settings:

0.4mm nozzle

0.2mm layer height

0.6mm layer with

4 walls

Arachne

Brim

I hope you like it :)