Sakaki Yumiko 1/6 Figure Base

While cleaning my Sakaki Yumiko figure, the plastic pegs snapped as I set it down, likely due to age and weight. Struggling to fix it, I ended up recreating the stand with metal pegs instead of plastic.

I made two versions one that is the size of the original base (150mm) and a smaller one (100mm) to save space in my DETOLF. 

After printing I used the following 3mm rods and cut them to size with a dremel. They needed to be hammered into the holes for a tight fit.

3mm rods - https://www.amazon.com/gp/product/B082ZP313B/

The rods need to be cut to the following sizes.

Left Foot:
1 x 24mm
1 x 12mm

Right Foot
1 x 30mm

The holes aren't perfect so the 12mm is kind of hard to get in but I found the longer 24 and 30mm rods line up better and are enough to support the weight alone.