Tools for 700R4 Transmission

I'm rebuilding a 700R4 automatic transmission and there were some tools required to make the job easier, so I designed them.

The o-rings on the input shaft that goes inside the oil pump need to be stretched before installing them. Stretcher.stl is the tool for that.

Then we will need to compress those o-rings back before installing the oil pump, this is Tube.stl.

I also made a simple plug for the case connector since I won't be using it. Case Connector Plug.stl. This one need to be printed in TPU/FLEX

Finally, Torque Cap.stl is a cap to seal the torque converter. It was useful for cleaning and painting it because there's always oil remaining in them. This one also need to be printed in TPU/FLEX

Printed in PETG, PLA would have work too, except for the case connector plug can torque converter cap that need to be printed in TPU/FLEX