LSI 9305-16i Fan Shroud for 60mm fan.

I printed this on its side with only necessary support. I'm not sure which is best for it. 

The fit is excellent. Be very careful with the clip on the heatsink as the heatsink is not rigidly mounted and the chip on the PCB has no metal cover. Twisting and moving the Heatsink too much can crack the chip. 

My advice is to shave off the clip as it's not really needed. 

This will also fit 9305-24i if you cut out the slot for the extra 2 connectors. Just use a negative volume in your slicer to remove them.

My appreciation to the designer: FireTime. A very precise and nicely done design!

I expanded the fan entry and angled it to accept a 60mm fan while not impinging on a motherboard heatsink or SSD.

I angled the fan to remove any deadzone and improve the air throughput. Likely unnecessary but it works well and doesn't result in backpressure on the fan. Quiet, effective outcome.