Elegoo Centauri Carbon Vented Riser

Greta model! Perfect print! Didn't realize it doesn't fit the CC2 (doh!)

It fits perfectly the CC and it looks good, my only concern is that I couldn't fully open the vents, just enough for them to function. I had to snap each fin with a flag screwdiver. It's very likely that I messed up the configuration, so it's kinda my fault. I've noticed that with the riser and the top cover placed, the chamber heat goes 2°C up, which is something I can live with in exchange of far less sound

I successfully printed the model and it functions as intended.

Perfect for height to allow for USB strain relief to avoid 103 error! Prints clean, stable, and looks great! (edited)

Thank you! Needed to raise the top to fit my new usbc wires. Painted the corners and it looks awesome.

I just can't get the bridge on the internal slide to work while printing for the life of me...

perfect print for my CC1 printed on my CC2

I am having a hard time printing this. The corners came out fine but the long parts of the frame just arent working out. what infill yall using? what settings?

After a day of fitting the riser, my LED's are only being held on my the clips.. the sticky backing has completely failed.. what is everyone using to secur it?

Great design.. probably the longest i've done so far (only had the printer 2 weeks).

Had to push each individual fin until they snapped to get it to loosen up but all ok then.

Printed using DEEPLEE PLA + 2.0

i printed on Purple PLA and it works perfectly!

Thank you very much for sharing. I printed in black PETG.