MicroSwiss NG Revo StealthBurner Switchwire Mount

**WARNING:** Use a flat flexible USB-C cable when using the ADXL345! A standard connector will interfere with the X Endstop Switch, might break your ADXL345 board and/or USB cable.

I was already using a MicroSwiss NG Revo prior to doing my SwitchWire conversion. So I wanted to make sure I used it.

Accomodates the stock Fan Duct and a FLY ADXL345

I'm also using the CR Touch Stealthburner mount from prasadp4009

Offset is

y: -24

BOM

• 8 x M3 heatset inserts
  • 3 x Mounting the extruder main body
  • 2 x Mounting the Fan duct
  • 2 x Mounting FLY ADXL345
  • 1 x Mounting the Clockwork Chain Guide
• 7 x M3 8mm screws
  • 3 x NG Revo main body (I used stock screws)
  • 2 x NG Revo Fan Duct (I used stock screws)
  • 2 x FLY ADXL345