Blink Camera Cover and Stand

A fresh recreation of a cover concept also including a stand that locks the camera inside the holder.

I wanted a cover to use outside and that could easily be moved and stood on various surfaces without falling over. I have used this to position it on a bird table and on the ground to film local wildlife in the garden.

I have printed it in PLA and had it outside for nearly a year in the wet UK winter and it has not deteriorated in any way.

I have printed it with 2 walls and 6% gyroid infill and it is rock solid and survived a UK wet winter.

Note. Both parts included as seperate files now.

No part of the model was reused, I just recreated the concept using my own measurements and incorporating a stand that also locks it in place within the cover.