Helldivers Helmet/Skull (display)

! The model shown in the picture was painted !

Already print-ready. The parts need to be glued together, while the connector helps to find the right position for gluing.The print plate model is a bit tricky to clean up and there will be a seam line down the middle, which you can fill with pollyfilla and coat it with a primer to make it less to none visible.You can also try to slice the raw helmet by tilting it on the chin at an angle, to print the helmet as a whole piece, but the risk of the print failing will be higher.

If you find a better way to slice the helmet without a noticeable seam line, you can share it in the comments.

Recommeded settings:

• 0,08 layer hight / high quality
• tree supports
• seam position: random