Wordle peg grid - necklace or brooch

Not only can you brag about your Wordle achievements on twitter but you can now proudly wear them as a necklace or a badge 😂

🟨⬛⬛⬛⬛
🟨⬛⬛⬛🟨
🟨🟩🟨⬛🟩
🟩🟩🟩🟩🟩

Place the colored pegs on the pegboard to replicate your Wordle achievement grid.

Use the 6 row board if you were struggling today, 5, 4, 3, 2 rows. Or even 1 row for the word-in-one lucky days.

The boards have a hole on each side to pull a string or a cable through.

Use it as a brooch or badge with the clipsable mount on which you can glue a brooch pin.

About the print :

Nothing special about the boards, I printed them facing flat on the print bed. I went for 0.2mm but any layer height should be alright.

--

Printing the pegs can be a bit trickier. I recommend checking the 3mf file to start with the setting I used, and adapt to your printer if necessary.

The stl has a modeled support built in.
I chose to print the pegs upright because it is the only orientation where the compliant holding fingers stay solid.
In my case I had no problem detaching the supports with a sharp blade.

A perfect bed adhesion is crucial to their printing because they have very little contact surface to the bed, and I didn't want to add a raft.