Print it out of PC Blend is MUST due to high drying temperature. Layer 0.2 mm. Use 10 mm brim and apply glue at PEI sheet.
Drying procedure : Fill box with layer about 1 cm high and put it to the middle of your printer bed and heat it to 105°C and dry for 1,5 hours. Some printers will stop heating after 30 minutes so start it again twice. After it cools down to room temperature immediately fit cover and “pour” it whenever your store dry silica gel or directly to container for filament spool as my favourite : https://www.printables.com/model/65922-silica-gel-spool-container
The author marked this model as their own original creation.