SINUS - Modern fruit bowl

I wanted to design a practical yet minimalistic fruit bowl. As a result, SINUS ("curvature" or "cavity" in latin) was created. This model is easy to print - orient the object on one of its sides, turn it 45° (if your print bed is square) and hit print. It doesn't need any supports!

Some recommendations:

• Use 0.24 mm layer height or smaller.

• To get a strong result, use 2 or 3 walls and 20% gyroid infill.

• Make sure to get good bed adhesion - a brim is recommended.

• There are 2 models, a 350 x 410 x 85 mm model ("SINUS - Big"), and a smaller version, to fit most printers ("SINUS - Small").

• You can scale the model to your liking, I also included the fusion 360 file so you can make other modifications.

Happy printing! Post your results here, its greatly appreciated.