NEW GUITAR WALL MOUNT

Guitar or Bass Guitar Wall mount

IDEALLY FOR SYMMETRIC GUITAR HEADS (Fender strats etc will fit but you may get a slight tilt due to the headstock geometry not being symmetrical)

hidden Screw Design. Fix bracket to wall then slot mount over

43mm and below necks

 - MUST print bracket laying down so layer grain runs the length or bracket

• MUST print the mount standing up. If not, I can not guarantee the strength of the part. 
• 0.2 layer height
• Minimum of 3 wall thickness
• 30% triangular infill
• The guitar mount works great in quality PLA, but stronger materials would be beneficial. 
• See the image attached for hole dimensions. I used M4 Screw. Approx 40mm in length
• Use suitable wall fixings to avoid failure. 

For Ukulele Wall mount