Modular 10 Inch Server Rack - Mounts for MikroTik hAP ax³ and CRS310-1G-5S-4S+

I created mounts for Natalie T's Modular 10 Inch Server Rack to mount MikroTik hAP ax³ and CRS310-1G-5S-4S+. The Mikrotik hAP ax³ uses a transparent base for the body of the access point that allows the device to be mounted horizontally or vertically. I created a shelf with two screw holes for mounting this base part. For designing the parts I used the original dimensions from this page and cut the width by 2 mm on each side to make them printable on my Prusa MK4. Under the shelf there is a slot for mounting a 2.5 inch SSD attached to the hAP via a USB-to-SATA adapter. The hAP ax³ can run containers and I use this SSD to run a container with pi-hole.
The shelf is attached to the back rails with 2 M3 heat inserts in the rails and 2 M3x12mm hex screws. Also needed for this part are 2 M3x12mm hex screws, nuts and washers to attach the transparent base part to the shelf and (up to) 4 M3x8mm hex screws to attach the SSD.

For the MikroTik switch CRS310-1G-5S-4S+ I created matching rack ears. To attach the ears to the switch I used 8 M3x10mm hex screws. 

I printed both the shelf and the rack ears with the front facing side resting on the build plate to get the texture of my build plate there. The parts I used besides my own were 3U rails, TPU feet, Cross Brace and the vented 2U side panels from Natalie T's project.

To assemble the parts I used M6 screws and nuts. M6 screws I used were button head type with lengths of 16, 20 and 30 mm.

Export files of the designs in .f3d and .step format are included if you want to adapt them for your own purposes.

Added custom mounts for MikroTik hAP ax³ and CRS310-1G-5S-4S+