Replacement Hinge Lid Pin for Beaba Baby Cook Solo

My friend Rachel broke the pins on the lid of her Beaba Baby Cook Solo. This is a simple replacement.  She reports it has been working fine for the past week. (Note: There is no contact of this part with food, it is part of a mechanical assembly.) 

This is a super simple model: really just a cylinder with the correct dimensions and a notch on the end. But handy if you need a quick replacement and don't want to model it yourself.  The original part is injection molded and thus unnecessarily complicated.

No special print instructions needed.  I used PLA, with 0.2 mm layer heights, printed tall-axis upright with no supports.  Be sure to clean the print bed well with isopropyl alcohol so you have good print adhesion (ignore slicer warnings about this).  There is a small screwdriver notch on one side (rotate it so this faces the top), which is present in the original part, but it not strictly necessary.