Stealth Press ZERO TS100 arm to fit on MGN9C carriage.
The M3x8 x4 are too long to screw the arm to MGN9C (unsure if is problem in original design too) so you have to use 4x M3x6.
Also my T100 from Miniware is too large for normal press plate to fit (seems original has the same issue). If you use minified version and have the same problem, use a_press_plate_wider_ts100_MGN9C_minified
part instead.
If you want to have arm flush with carriage, print both press plate and arm from minified folder. Always make sure that upper guard bumper (keyback holder) is low enough to protect the carriage from going off the rail.
If however for some reason you want to maintain same dimensions with original, use arm__ts100_MGN9C-r0_x1. It is of same height like the 9H version (and thus slightly exceeds the carriage height) along with original a_press_plate_ts100-_r10_x1.
Parts are already print oriented.
r0 - the bigger arm__ts100_MGN9C-r0_x1
r1 - minified version
r2 - added wider press plate due to incompatibility with Miniware T100
The author remixed this model.
Redid TS100 arm to fit on MGN9C carriage.