Simple VESA stand

A very simple stand for monitors with VESA 75x75 mounting system. 

• Made to just about fit an Ender 3 bed. 
• No tools needed, other than 4 M4x15 screws (for the VESA mount itself). 
• No supports or brim needed, works fine with PLA.
• Only modification needed is a dovetail joint in the middle of the arm, which I've added in the .3mf file. 

It was made specifically for my small 18" ASUS monitor, which it does hold, though it is perhaps not as stable as I would've hoped for. 

Hope this helps someone who lost their monitor stand, like I did.