Back center for 350 mm, with pass through for canbus/filament

A top hat centre piece with holes for the canbus cable gland, and PTFE guide.

If you have a top hat on your voron, you must want the gantry to be able to move higher on the printer. Moving the cables and filament guide will help. Also, it will reduce the wear on the can bus cable – no more flexing on the cable chain.

Note: my cable gland attached well, my ptfe guide to so much, but with a little patience it went in securely.

Closed the voron  logo and 4 holes for the optional led mounting plates.

Openned 2 holes for passing the canbus cable- m12 gland, and a PTFE guide, M10