Voron 1.8 X-Endstop Stealthburner

Stealthburner on Voron 1.8 does not reach lower joint with its endstop and I would need to print whole new lower joint with some spacer reaching to endstop so instead i designed a little bracket that is held with M5 screw that screws into 2020 T-Nut and holds endstop with 2x M3 screw. (you will need 2x M3 heat insert). I also put a little double side tape just to make sure it does not rotate :D

It's around ~7 minute print,

 Just make sure that your leadscrew doesnt interfere - mine were just short enough