Click-Screw Fidget

- Small, 3-piece fidget designed to be used with one hand or two.  Satisfying spinning, clicking, and screwing.
- Quick print with low filament cost (approx 18g).
- Support-free.  No adhesive or external hardware needed for assembly (100% 3d printed).  
- 2 different versions available.  Standard and Keychain

**This design is uploaded with a non-commercial license. Downloading this file does not grant you the right to sell commercially.

If you would like to consider gaining access to ALL of my models and the rights to print and sell them, you can check out my Patreon at
https://www.patreon.com/thinair3D

Printing Info:
These are just the settings I used to test the model, feel free to use whatever settings work best for you.
- FDM or Resin: FDM
- Scaling: Can be scaled up.  Scaling down may be fine to a certain degree, but afterwards may cause issues with the threaded parts/snaps.
- Supports: None
- Infill/Perimeters: 10-15% infill + 2 wall loops.  (extra wall loops for a stronger keychain)
- Nozzle Size: 0.4
- Layer Height: 0.2
- Print Time: Approx 1 hours 8 mins (Bambu X1C)
- Filament Usage: Approx 18 grams (Bambu X1C)