I edited the first version so that it fits on the Prusa XL print bed Support material expansion first layer must be set to 0 otherwise the support will be above the print bed.
By separating the body in the slicer you can make two parts out of it
I use lighting from IKEA
https://www.ikea.com/ch/de/p/skydrag-led-lichtleiste-arbpl-klschr-sensor-dimmbar-anthrazit-70529229/
https://www.ikea.com/ch/de/p/silverglans-lichtleiste-led-fuer-bad-dimmbar-weiss-70528668/#content
Prusa XL-Kamera und Halterungslichtist lizenziert unter Creative Commons Attribution-NonCommercial 4.0 International© 2 von Roman Nüesch
The author marked this model as their own original creation.