Viking portrait in grayscale (HueForge)

My first attempt at printing my own HueForge design from my Midjourney prompt. 

Still playing around with the right exposure etc. and some stringing I still need to try and remove or avoid in future (suggestions on both welcome) 

Creality K1C, 2h 8min

Project: Viking 3 0.08 3.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 130x130mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.1mm

Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA Sunlu Natural Transmission Distance: 21
PLA Sunlu High Speed Grey Transmission Distance: 0.9
PLA+ Sunlu Silver Transmission Distance: 2
PLA Sunlu Meta White Transmission Distance: 8
PLA Creality Ender White Transmission Distance: 3
This print uses 6 unique filaments

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Natural
At layer #13 (1.12mm) swap to Grey
At layer #14 (1.2mm) swap to Silver
At layer #17 (1.44mm) swap to White
At layer #19 (1.6mm) swap to White for the rest.