Roads Iphone Stand

One piece Iphone stand 60° for convenience, ProMax Iphones should also fit fine. Fill it with Form A (standard) M20 DIN 125 washers, no internal screw needed, washers are held down by Magsafe. Fits about 23 washers on the pin.  On nightstand add neoprene layer on bottom for antislide. Pull cord through first and put the cord to the front or you will have to remove the washers again

Dont forget to move the seam to the back. Printed in ABS, PLA has different shrink you may have to print it 99% size. No Supoort needed.

You may have to enlarge the back hole for USB-A Connector. The STEP file is uploaded so its easy to do

Washers:

https://amzn.eu/d/aJO4i2A