Simple lid hinge for Voron 0.1

A two part hinge and light assembly for the Voron 0.1 that lifts the lid a bit and adds lights.
0
1
0
21
updated January 29, 2025

Description

PDF

I have a Voron 0.1 built from a Siboor kit some time ago and I am too cheap to buy the parts to update the lid to the 0.2 design.

This does take a larger printer to print it in one piece.  The top and bottom can both be printed without supports when printed top side down.  Take a 3mm tap to all the holes, particularly the pins the hold the bottom half of the hinge to the printer or they may break when putting a 3mm screw in.  The parts can be printed with little infill as they are not structural but the split pins on the bottom should be 100% infill for strength.  If printing at higher temps is a thing then printing the hinge with more than just PLA would likely be a good thing.

 

Extras needed

8  M3x10 screws

2 strips of 12 LEDs of your choice

Wire to connect it up.

Model origin

The author marked this model as their own original creation.

License