Angled Foregrip (AFG), Picatinny, 6-32 thru-bolted (SFW!)

This ergonomic foregrip prints well without supports and clamps securely to the firearm without cracking.

Slide it onto a STANAG 4694* rail, then use two 6-32 x 1.25" socket-head screws and two nuts to clamp it down.

In the photos, this is mounted on my daughter‘s KelTec™ CMR30 — a .22 Magnum carbine.

SFW! I dispute the NSFW status placed on this model by Printables staff. If your employer has a problem with you looking at this handle, then you seriously need to find a less oppressive workplace.

* STANAG 4694 (a NATO standard) and MIL-STD-1913 (the American equivalent) define a nifty type of slotted accessory rail widely known as a “Picatinny rail”. This is meant to mount on any such rail on the underside of a rifle or personal defense weapon.

See Also

• Jérémy’s NATO Weaponry Collection

The original used 6-32 x 1" screws with no nuts. The creator's update used smaller M3 screws with nuts, and required supports to print.

My remix uses beefier 6-32 x 1.25" screws, flexes a bit more to allow for better clamping, and eliminates the need for supports.