Ho creato questo porta bobine ruotato di 90° rispetto all'originale, utilizzando il tubo e tutte le viti originali.
Il pezzo è venuto molto robusto senza rischi che si rompa. E' appoggiato sulla barra originale ed và perfettamente innestato nella sua sagoma. Il foro dove va il sensore è filettato M3 con le dovute tolleranze, si avvita e si stringe perfettamente. Anche il tubo dove poggia la bobina entra a millimetri nel foto e si blocca col suo dado.
L'ho stampato in PLA con 15% di infill.
Supporti necessari
PS: ho apportato una modifica che non c'è nelle foto, ho creato un'apertura sotto dove passa il filo del sensore del filamento, così da non doverlo passare sotto come ho fatto io.
Versione V7: allargata la fessura per il passaggio del filo in modo da avere più tolleranza
I created this spool holder rotated 90° compared to the original, using the tube and all the original screws.
The piece came out very sturdy with no risk of breaking. It rests on the original bar and fits perfectly into its shape. The hole where the sensor goes is threaded M3 with the necessary tolerances, it screws and tightens perfectly. Even the tube where the spool rests enters the photo to millimeters and locks with its nut.
I printed it in PLA with 15% infill.
Necessary supports
PS: I made a change that is not in the photos, I created an opening underneath where the filament sensor wire passes, so as not to have to pass it underneath as I did.
V7 version: widened the slot for the wire passage to have more tolerance
The author marked this model as their own original creation.