Steven Mark TPU

This is a 3d print design to build your TPU.
 

This is the STEAP version of it. Work in progress!

I made an ESP32 WROOM version to control the 3 frequencies.

To configure the TPU settings from the ESP32:

1. Upload the firmware using ARDUINO IDE or other
2. Connect it on USB-C
3. Use your phone or desktop computer and connect to the Wi-Fi SSID: TPU…
4. Password is TPU12345
5. Once connected go into your browser to 192.168.4.1
6. You can change a lot of thing from there including the SSID password to connect to the TPU

The STEAP is not an easy TPU to do but I will update the instruction over time.

Right now I put all my STL file to be able to make it and tool to help to wing the coil since it's not an easy task :).