Tall Vertical Phone Holder

Simple stand for holding a phone vertically with adjustable height. Uses any reasonable length of 2020 extrusion.

This was nominally designed for recording or photographing with a phone close to the ground, but high enough that most common phone holders weren't tall enough.

Internal dimensions of cradle: 87mm wide x 15mm deep

Required hardware:

• 1x 2020 extrusion, any length
• 1x M4 T-nut
• 1x M4x8mm screw

If the dimensions aren't quite right for what you need, send me a message. I'd be happy to make a modified version for you.