This model allows you to put the strings on your guitar before you glue the bridge in place. This allows you to determine the optimal location for the bridge--both side to side as well as fore and aft for intonation.
**Note I've be having issues for the part deforming. I'm going to reprint with PET-CF instead of PLA. I recommend using many (6+) side and top/bottom layers as well as using reinforced filament. Remember, that is probably around 150-160+ pounds of force pulling from the strings!
I would also recommend you make sure that the ends (at the model not the tuners) are laying “flat” and then tape them in place so as to avoid scratching the guitar soundboard!
The author marked this model as their own original creation.