Gridfinity Expo white board kit organizer

I built this Gridfinity 2x3 block using Stu142's excellent FreeCAD parametrid Gridfinity blank.  Stu142 did most of the lifting on this.  This took about 10 minutes to model.

The model is printed in white PLA.  I chose to slice at 0.18mm layer height but, considering what it is, it would do well at 0.2mm or even a bit higher.  No support needed.

Printed on a Sovol SV08 with Mainline Klipper.

I turned Stu142's wonderful Gridfinity blank into an Expo white board kit organizer.