Angel robot wings attachment for the Dummy 13 by Soozaphone.
Print Settings
- Print wings flat to bed with protrusions pointing up
- Layer Height 0.1-0.2mm
- Supports - None
- Brim - helps with the backpack for wings
- Print the Backback attachment standing up in the correct orientation.
Assembly
The
- Backback Should connect to the hole in the back of the Dummy 13 Upper Torso. Tested on 130% & 160% model.
- Insert wings as a friction fit with the raised profile facing towards you. You can also glue them in place if needed.
Tags
The author marked this model as their own original creation.