Reinforced IKEA Faktum leg clip
This mix has tighter tolerances and is stronger where it mounts to the kick board.
3
40
1
140
updated
January 26, 2025
Description
PDFI needed to replace the IKEA Faktum kick board leg mounts as a couple had broken. This mix is based upon a great design by @TimAngus (https://www.printables.com/make/2364636) but as I found when printing with PETG the clip was looser than the original IKEA clip. This version holds the kick board rail mount and the legs with a sliding fit. I suggest only printing it with PETG as PLA might not flex enough.
Model origin
The author remixed this model.
Differences of the remix compared to the original
Changes in tolerances. Reduced the inside diameter of the Clip. Increased the thickness of the part which attaches to the kick board mount and adjusted its size for a sliding fit.
