Camera mount screw 1/4-20

Edit:

Printing this on it's base is actually not very strong, the shaft is easy to snap with just a little too much torque.

I would recommend either of my newer versions, which print on their side resulting in a much stronger print:

• https://www.printables.com/model/1165599-camera-mount-screw-14-20-flat
• https://www.printables.com/model/1165608-camera-mount-screw-14-20-flat-v2

------------------------------

This is a standard ¼-20 camera mount screw

Highly recommended to print at high resolution for the screw threads to be decent.

Resin printing would also be appropriate for this.

I went with:

• .12 layer height max
• 10% Gyroid infill
• 6 perimeters (so the screw shaft is solid, not hollow on a .4 nozzle)
• No supports, brim, or raft required